How the GaGe Digitizer was used: The GaGe digitizer, a high-speed data acquisition device, was employed to enhance the resolution and accuracy of metallic magnetic calorimeters (MMCs). This digitizer was critical for sampling and converting analog signals to digital, allowing precise measurements of gamma rays. It provided the necessary flexibility with selectable input voltage ranges and variable acquisition rates, essential for optimizing the performance of the MMCs.
How the GaGe Digitizer was used: The GaGe Digitizer was employed to collect and process the power traces from the lidar system. Specifically, it was used in the hardware setup to digitize the voltage signal after it was amplified and filtered. This digitization is crucial for converting the analog signals into digital
How the GaGe Digitizer was used: The research utilized the GaGe CompuScope 14100 oscilloscope card to digitize ultrasonic signals. With a 14-bit resolution and a 100 MHz sampling rate, this digitizer enabled precise recording of the ultrasonic waves traveling through the pulp suspensions, which were later analyzed to determine phase velocity and attenuation.
How the GaGe Digitizer was used: The GaGe digitizer card was used to read out the CID camera’s data. In the experiments, the CID 4150 camera captured X-ray images, which were then processed using the 12-bit GaGe digitizer card. This allowed for the precise recording of the camera’s response to X-rays, facilitating the necessary calibrations. The digitizer’s high resolution and fast readout rate enabled the accurate and timely collection of data, which is essential for comparing the CID’s response with a standard Si(Li) detector.
How the GaGe Digitizer was used: The GaGe Digitizer was employed to capture high- resolution data from the magnetic microcalorimeters (MMCs) during gamma spectroscopy. It facilitated the precise measurement of gamma-ray signals, enhancing the detection and analysis capabilities of the MMC g-spectrometer.
How the GaGe Digitizer was used: The system utilizes a GageScope 8500-PCI waveform digitizer to capture radar data. This digitizer, supporting DOS, Windows, and Windows NT, required a complex start-up code, but the system successfully employed a dual-boot setup with Linux and DOS to configure the digitizer efficiently.
Industry:
Medical/Pharmaceutical, Testing Labs & Research Centers
The GaGe Digitizer was used to measure the electrical field induced by the TMS coils. The digitizer recorded the voltage differences captured by a dipole probe in the head model, allowing researchers to compute the electrical field strength and distribution.
How the GaGe Digitizer was used: Incorporating innovative hardware design and signal processing techniques, the system efficiently measures ozone concentration and aerosol profiles. A recent addition of a 2D scanning system enhances its capabilities, allowing measurements in a vertical plane.
