Brands

Hyper Remote Laser Sensor Customer Case The customer is at the prototype stage for building a hyper remote sensor which will fly over the ocean and be able to see 100 to 200 feet below the surface. The sensor is being designed in order to determine the composition of the ocean and the ocean floor. This remote sensor will be extremely useful in the detection of pollution and studying the way pollution is being distributed by ocean currents. It will also be useful to the military (navy) for creating mine-finding systems. A deep blue laser will be used to [...]

Laser Induced Fluorescence (LIF) Customer Case A customer has developed a breakthrough technique for the application of laser-induced fluorescence (LIF) detection to high performance liquid chromatography, capillary e lectrophoresis, sequencing and microbial analysis. The technique involves using fluorescence decay curves at multiple wavelengths simultaneously, leading to true 3-D fluorescence spectroscopy (i.e., fluorescence intensity as a function of wavelength and delay time relative to pulsed excitation). They have a requirement to increase the laser pulse repetition frequency (PRF) from 20-50 pulses per second to 500-1000 pulses per second. Basically, they want to collect and time resolve the fluorescence signal for [...]

Optical Spectroscopy Customer Case A customer who is completing his doctorate in Chemistry at the California Institute of Technology has identified the need to measure fast optical signals using fast photo-detectors. The signal pulse width is as short as 2ns. Signals will be acquired at a 1KHz repetition rate, with a record length of 1,000 to 10,000 data points. GaGe Case Solution The CompuScope 82G, an 8-bit, 2GS/s A/D and Scope card for PCI Bus, is the best solution for this customer. With relatively small record sets, the customer is able to keep up with the 1KHz Pulse Repeat [...]

Kinetics of Preotein Dynamics Customer Case The customer is measuring kinetics of protein dynamics with a time scale of between a few nanoseconds and about a hundred milliseconds. The customer's two response signals occur after a few-nanosecond-pulse excitation that repeats at a rate of 1-10Hz. This requires a bandwidth from DC to a few hundred MHz, sampling speed of about 1-2GS/s, and processing time for one acquisition that is less than 1-0.1secs. An analog signal of about 10-30mV comes from a Photo-Multiplier Tube (PMT) or a photo-diode with a trans-impedance pre-amplifier. The customer is currently using a couple of [...]

Radioactive Nuclear-Decay Detection Customer Case The customer has a requirement for PC-based waveform digitizer cards to digitize shaped pulses derived from nuclear-decay detectors. These pulses vary in their rate (frequency of occurrence) and amplitude. Their shape is approximately Gaussian with a full-width at half the maximum amplitude (FWHM) of 3-5 microseconds. The characterization of each pulse is critical for the accurate and precise determination of the activity of radioactive materials. These materials have very low count-rates (0.02 pulses per minute) to relatively high count-rates (>1000 pulses per minute). Important to the measurement process are the speed and reliability of [...]